Walkera 36 setup manual

This will also help prevent a boom strike. The swash does not move with TH with these settings. These settings are for hovering and slow flight only. These settings have very low servo travel which will make the controls less responsive to stick input if you need to tame down the controls even more. Adjust the pot s to make the helicopter more response or more stable.

You want a balance of good response and stability. If you adjust the pot s too high the swashplate may rock back and forth in flight. I recommend you first try the factory settings. Most of the time the factory settings are very good. Be careful when you turn the pot. I would use the plastic screwdriver that came with the helicopter to turn the pot. This is a list of settings that I have seen on different receivers. The settings available on a receiver will vary depending on which model receiver it is.

Use when leveling the Swashplate and making adjustments. This will give you zero degree negative pitch for indoor flying or outdoor flying with no wind. The heli will not slam to the ground if you pull the throttle down to fast due to having negative pitch. Do not use this for stunt modes, only use this for normal mode. The helicopter will hover about 1 line past half throttle. These settings will help minimize damage in a crash as the swash and blades will be at mid stick zero degrees pitch.

This will also help prevent a boom strike. The swash does not move with TH with these settings. If you are setting up pitch curves use these settings below first then switch to the settings above for when you fly.

Adjust the pot s to make the helicopter more response or more stable. You want a balance of good response and stability. If you adjust the pot s too high the swashplate may rock back and forth in flight.